Need help?Do you have a question about the Bang & Olufsen Beogram 9500 and is the answer not in the manual?
General| Speeds | 33 1/3, 45 RPM |
|---|---|
| Speed control | Electronic |
| Platter | Aluminum |
| Drive system | Belt drive |
| Tonearm | tangential |
| Cartridge | MMC 2 |
| Rumble DIN unweighted | -55dB |
Detailed circuit diagram for PCB 2, showing component connections.
Details specific points for lubrication and how to apply it.
Details specific lubrication points and procedures in German.
Details specific lubrication points and procedures in French.
Procedure for adjusting the in/out travel of the pickup arm.
Procedure for adjusting the lift and lower function of the pickup arm.
How to adjust and check the turntable speed (33/45 RPM).
Adjusting the height of the pickup arm relative to the indicator arm.
Adjusting the pickup arm for correct parallel alignment.
Adjusting the distance between the top plate and turntable.
Centering the drive mechanism relative to the top plate.
Adjusting the height of the pickup arm system.
Ensuring the pickup arm is parallel to the detector arm.
Adjusting cartridge parallelism when replacing the arm.
Adjusting turntable height and centering the drive mechanism.
Step-by-step instructions for mounting the wire drive mechanism.
Guidance on fitting camwheels using chassis holes.
Cautionary notes on handling the pickup arm during servicing.
Detailed steps for refitting a detached pickup arm.
Instructions for mounting the drive cable in German.
Step-by-step guide to conducting the insulation test.
Critical safety and operational notes for the insulation test.
German instructions for performing the insulation test.
French instructions for performing the insulation test.
Crucial reminder about avoiding damage during the test.
To Next Page