Bang & Olufsen BeoLink Wireless 1

To Next Page

To Previous Page

Power Link setup

If your link room product is a pair

of active speakers, they must be

connected to BeoLink Wireless 1

with Power Link cables

This setup also requires an ‘IR-eye’,

in order to be able to operate the

the system – either by close-up

operation, or with a Bang & Olufsen

remote control.

For operation of such a setup, refer

to pp. 6–8 in this Guide.

For information about installation

of the BeoLink Wireless 1 system,

refer to ‘Set up BeoLink Wireless 1’

(pp. 9–15) in this Guide.

For information about how to set

up the main room system and the

link room products, refer to the

Guides enclosed with the products.

Link room system with active speakers and an ’IR-eye’ – set up with a

Power Link connection .

Bang & Olufsen BeoLink Wireless 1 - Power Link Setup