MASTER LINK
12
For the Beolink 1000 terminal the key sequence is the following:
Beovision: “digit”
Beomaster/BeoSound: “digit”
Link room products: “digit”
The digit sequence to be used depends on the setup.
Option 0 = No IR reception
Option 1 = Two IR-eyes in the same main room
Option 2 = One IR-eye in the main room
Option 4 = Link room product connected to one or two main room
products in the same room
Option 5 = Two IR-eyes in the same link room
Option 6 = One IR-eye in the link room
It applies to most setups that they are delivered with the correct option
setting from the factory, and they are thus “ready for use”.
However, since in some situations you may have to work with products
that have been installed before, e.g. in connection with a house that has
been rebuilt, the correct option is indicated at ALL illustrations, even
those which are “ready for use” from the factory.
NOTE!
If the option programming is not executed
correctly, a malfunction will occur.
To Next Page
Loading...
Need help?
General
