BANGGOOD Bugs 7 - Prepare the Remote Controller; Install the battery of remote controller

Battery installation
Install the battery of remote controller
!
Attention: The battery should be installed firmly, failure to do so may affect the flight safety of your aircraft.
The aircraft may crash due to power-cut during the flight.
Insert the fully charged battery into the aircraft battery box (see as the picture), ensure the battery install correctly.
Pic. 1 Pic. 2 Pic. 3
Step 1: Unfold the hand sticks and open the battery door (Pic. 1);
Step 2: Install 2*AA batteries into the battery compartment according to the given polarity (Pic. 2);
Step 3: Close the battery compartment (Pic. 3).
Prepare the Remote Controller
!
● Insert batteries with correct polarity.
● Non rechargeable batteries are not to be charged; the transmitter need 2*AA batteries for work.
● Do not mix old and new batteries.
● Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
● Rechargeable batteries are to be removed from the aircraft before being charged.
● Rechargeable batteries are only to be charged under adult supervision.
● Exhausted batteries are to be removed from the aircraft.
● The supply terminals are not to be short-circuited.
Bugs 7 User Manual
-2-