Banzai WAVE CRUISER - Product Setup Instructions

Setup Instructions
1.
3.
4.
2.
I
III
II
3
4
A
1. I During shipping,
parts 3 and 4 are
assembled and must be
separated prior to
assembling the toy.
II Press the release
latches “A” and push
part 3 downwards
while pulling part 4
upwards.
III Separate pipe cover
from propeller pipe.
2. Placement Diagram:
Use in swimming pool
only, not on pavement
or other surfaces.
3. Roll out Motorized
Wave Cruiser™.
Inspect for holes, tears
or other damage.
4. Inflate the Motorized
Wave Cruiser™ with air
until it is halfway full.
See diagram for air
chamber locations.
NOTE: For easy air
inflation, use a manual
air pump designed
specifically for plastic
inflatable.
5 BANZAI 15733 20121130