Baofeng GM-5X - Page 30

14
VOICE - Voice
Reminding
MENU+14
OFF
CHI
ENG
*Allows audible voice confirmation of a key press.
15
ANI-ID -ANI-ID
MENU+15
It can be programmed by software
16
DTMFST - DTMFST
MENU+16
OFF: No DTMF Side Tones are heard
DT-ST : Side Tones are heard only from manually keyed DTMF
codes
ANI-ST: Side Tones are heard only from automatically keyed
DTMF codes
DT+ANI : All DTMF Side Tones are heard
17
S-CODE - Signal Code
MENU+17
1,…,15
18
SC-REV - Scanner
Resume Method
MENU+18
TO : Time Operation - scanning will resume after a fixed time has
passed
CO : Carrier Operation -scanning will resume after the signal
disappears
SE : Search Operation -scanning will not resume
19
PTT-ID - PTT-ID
MENU+19
OFF: No ID is sent
BOT: The selected S-CODE is sent at the beginning
EOT: The selected S-CODE is sent at the ending
BOTH : The selected S-CODE is sent at the beginning and ending
20
PTT-LT – PTT ID delay
MENU+20
0,1,2…,50ms
*PTT-ID Delay (milliseconds)
21
MDF-A - Channel A
Display Mode
MENU+21
FREQ: Displays programmed Frequency
CH: Displays the channel number
NAME: Displays the channel name
*Note: Names must be entered using software.
22
MDF-B - Channel B
Display Mode
MENU+22
FREQ: Displays programmed Frequency
CH: Displays the channel number
NAME: Displays the channel name
*Note: Names must be entered using software.
23
BCL – Busy Channel
Lock-out
MENU+23
OFF
ON
*Disables the [PTT] button on a channel that is already in use.
The transceiver will sound a beep tone and will not transmit if
the [PTT] button is pressed when a channel is already in use.
24
AUTOLK –Automatic
Keypad Lock
MENU+24
OFF
ON
*When ON, the keypad will be locked if not used in 8 seconds.
Pressing the [# ] key for 2 seconds will unlock the keypad.
25
SFT-D – Frequency
Offset Direction
MENU+25
OFF: TX = RX (simplex)
+: TX will be shifted higher in frequency than RX
- : TX will be shifted lower in frequency than RX
26
OFFSET -Frequency shift
amount
MENU+26
00.000…69.990
*Specifies the difference between the TX and RX frequencies
27
MEM-CH - Store a
Memory Channel
MENU+27
000…127
*This menu is used to either create new or modify existing
channels (0 through 127) so that they can be accessed from
MR/Channel Mode
28
DEL-CH - Delete a
memory channel
MENU+28
000…127
*This menu is used to delete the programmed information from
the specified channel (0 through 127) so that it can either be
programmed again or be left empty.
29
WT-LED- Standby
Backlight
MENU+29
OFF/ BLUE/ ORANGE/ PURPLE
30
RX-LED- Receive
Backlight
MENU+30
OFF/ BLUE/ ORANGE/ PURPLE