TX-LED- Transmit
Backlight
OFF/ BLUE/ ORANGE/ PURPLE
SITE: Sounds alarm through your radio speaker only
TONE: Sending alarm tone
CODE: Sending alarm code
VHF:136-174MHz
UHF:400-480MHz
*In VFO/Frequency mode, sets [A] or [B] to the VHF or UHF
band.
TDR-AB - Transmit
selection while in Dual
Watch mode
OFF
A band transmit (Upper row frequency)
B band transmit (Bottom row frequency)
*When enabled, priority is returned to selected display once the
signal in the other display disappears.
STE - Squelch Tail
Elimination
ON
OFF
*This function is used eliminate squelch tail noise between
pofung handhelds that are communicating directly (no
repeater). Reception of a 55 Hz or 134.4 Hz tone burst mutes the
audio long enough to prevent hearing any squelch tail noise.
RP-STE-Squelch Tail
Elimination
OFF/ 1,2,3…10
*This function is used eliminate squelch tail noise when
communicating through a repeater.
RPT-RL - Delay the
squelch tail of repeater
OFF/ 1,2,3…10
*Delay the Tail Tone of Repeater (X100 milliseconds)
FULL: Performs an LCD screen test at power-on
MSG : Displays a 2-line power on message
*Controls the behavior of the display when the transceiver is
turned on.
OFF
ON
*Sends an end-of-transmission tone to indicate to other stations
that the transmission has ended.
VFO: Menu initialization
ALL: Menu and channel initialization
*Resets the radio to factory defaults, with some exceptions.
Appendix F. - CTCSS Table
CTCSS CHART (Hz)