Rev Final 1/9/2104 AD7FO, AE7RJ, KE7RAP
accidently transmit you will be heard on that frequency (police, weather, taxi, fire, etc.) The
way to avoid this is to use the programing software and enter a transmit frequency of
000.000 MHz). We have not found a way of entering 000.000 in the manual programing
mode.
Additional “Menu“ choices that may be of interest
All of these modes are accessed by pressing the MENU key then using the 65up down arrow
keys to get to the menu item then pressing the MENU key and the 65up down arrow keys or
entering data to make choices.
Menu # Function
# 0 SQL Set Squelch threshold (0 is no squelch 9 is max squelch))
# 1 STEP Tuning step size using the 65up down arrow keys
# 2 TXP Set transmit power (High or Low)
# 3 SAVE Battery Save Mode (Off or 1,2,3 or 4 Hours)
# 4 VOX (ON or OFF and sensitivity)
# 5 WN Wide or Narrow Bandwidth (5 KHz or 2½ KHz)
# 6 ABR Display illumination (Off or 1 to 10 Seconds)
# 7 TDR Dual watch (on, A or B)
# 8 BEEP Tone on key stroke (ON or OFF)
# 9 TOT Transmitter On Time, in seconds
# 11 RCTCS Receive CTCSS (set tone or off with the 65up down arrow keys)
# 13 TCTCS Transmit CTCSS (off or select tone with the 65up down arrow keys)
#14 VOICE Select language (English or Chinese)
# 19 PTT-ID (Off, BOT, EOT, BOTH)
# 20 PTT-LT Delay PTT for coding (0 to 50 ms)
# 23 BCL Busy Channel Lockout (on or off)
# 24 AUTOLK Automatic Keyboard Lock (on or Off)
# 25 SFT-D Repeater Offset (+,-, off)
# 26 OFFSET Repeater Offset Frequency
# 27 MEM-CH Memory Channel number entry
# 28 DEL-CH Delete Channel number entry
#33 BAND Band select VHF or UHF (same as BAND button)
# 34 TDR Dual watch (on, A or B)
#39 RODGER places tone at end of transmission (On or Off)
# 40 RESET ALL Restores default settings (use with caution, your stored data will
be lost)
To Previous Page
Loading...
