Why is my Baofeng Transceiver programming software not connecting to the radio?
If your programming software isn't connecting to the Baofeng Transceiver, ensure the cable is firmly pushed into the radio. Also, verify that the correct COM port is selected in the software; COM5 is often effective.
What causes low power on VHF low with Baofeng UV-3R Transceiver?
The low power output on VHF low with the Baofeng Transceiver is a known characteristic, not a defect. Forum discussions suggest changing one of the VHF PA coils to potentially improve this.
How to stop the siren/alarm on a Baofeng UV-3R Transceiver?
To stop the siren or alarm on your Baofeng Transceiver, press the PTT (Push-To-Talk) button.
What to do if TX lock on VHF with Baofeng UV-3R?
If you experience a TX lock on VHF with your Baofeng Transceiver, especially when using high power with the supplied earpiece, it's likely due to RF interference in the earpiece lead. A suggested solution is to wind the lead through a ferrite core to stop this.
Defines the Baofeng UV-3R as a compact transceiver for VHF/UHF amateur bands, functioning as an SDR.
Provides clear instructions on how to perform a factory reset on the UV-3R radio.
Guides users through the steps to manually program memory channels on the UV-3R.
Explains the process and functionality of using the programming software for channel configuration.
Offers troubleshooting steps for common issues when the programming software fails to work.
Explains the requirement for an Amateur Radio license for operating the UV-3R.
General| Output Power | 2W |
|---|---|
| Channels | 99 |
| Operating Voltage | 3.7V |
| Antenna Impedance | 50 ohms |
| Modulation | FM |
| Operating Temperature | -20°C to +60°C |
| Frequency Range | 136-174 MHz |
| Battery | 3.7V 1500mAh Li-ion |
To Next Page
