21618-A-01-09 15
DE
GB
F
NL
If no button will be pressed during 6 hours, the machine switches off automatically without draining.
Follow the description below during the next switch on:
– Push the ON/OFF button
➀
.
– Push the Drain button
➂
and wait, until the machine is drained and switched off.
Restart the machine as described at chapter 5.
TROUBLESHOOTING GUIDE
TYPE OF FAILURE POSSIBLE CAUSE REMEDY
Poor wash result
Stripes and staines on
glasses.
Rinse aid concentration too high. Reduce quantity (see instructions).
Hard water or high mineral content. Check water quality.
Obtain details from local water authority.
Recommended values:
Ideal degree of hardness is up to 4° Clark.
Ideal conductivity value is max. 100 µS/cm.
Rack is not suitable for type of glasses
(sloping).
Use appropriate racks to create a sloping position
which allows water to drain away from cavities.
Insufficient rinse aid concentration
causes staines.
Increase quantity (see instructions).
Machine with softener:
wrong type of salt used.
Use only granular regeneration salt.
Other malfunctions
Glasses are totally or
partially cloudy.
Surface of glasses is rough and porous,
this is called glass corrosion.
This is not caused by a malfunction on the machine.
Replace with new glasses.
Glass breakages. Use of inappropriate glass racks. Use appropriate racks.
Machine suddenly stops
during wash program.
Machine is connected to a "maximum
power supply unit" which cuts out the
energy consumer at a given point, or
machine is interlocked with another
energy consumer unit.
Connect machine separately (call electrician).
Blown site fuse. Check site fuses.
To Next Page
Loading...
