bar aid 400 - Priming the Suction Hoses

8 21618-A-01-09
DE
GB
F
NL
START-UP
Push Start button
➁
. At the temperature indicator Wash
➄
appears
"- - 1". Wait until the indicator displays "- - 0".
Close the door.
The machine switches off and is now ready for operation.
4.4 PRIMING THE SUCTION HOSES
ATTENTION:
The machine has to be switched off.
Open the door.
Push Program button
➃
and Drain button
➂
simultaneously until the
upper Display
➄
shows "boF".
Push Program button repeatedly, until "H02" is displayed.
Close the door.
In the upper Display appears "SF1", in the lower one "0".
4.4.1 DETERGENT SUCTION HOSE
To prime the detergent suction hose between the injector and
container:
Push and hold Start button
➁
for 1 minute approx.
4.4.2 RINSE AID SUCTION HOSE
To prime the rinse aid suction hose between the injector and
container:
Push the Program button
➁
again.
In the upper Display
➄
appears "SF2", in the lower one
➃
"0".
Push and hold Start button
➁
for 3 minutes approx.
By using a longer suction hose, hold the Start button about
6 minutes.
4.4.3 TERMINATION OF HOSE PRIMING
Do not press any button for 10 seconds.
–
–
–
–
–
–
–
–
–
–