Baracoda D-Fly - The Different Connection Methods

Baracoda D-Fly & D-Fly2– User Guide v2.4 - 8 -
Data Capture
for Workforce
in Motion
4.3. The different connection methods
There are two (2) different ways to create a connection from a Host and a scanner:
- Slave mode (by default)
The Host (PC, BaracodaManager, …) is creating the connection onto the scanner.
- Master mode
The scanner is creating itself a connection to the recorded Host Bluetooth address. This connection
attempt is set after a scan of barcode. The configuration of Host address (on which the scanner will set
up a connection to) can be done:
o Via BaracodaManager software (v3.35 min).
o Via scan of barcodes.
All usage modes (Real Time, No Data Loss, Batch) are obviously available.