BarAid 500 - Cycle Counter; Water Consumption Counter; Remaining Water Quantity Counter for External Water Treatment; Termination of Setting Mode or Counter Display

21617-A-01-09 13
DE
GB
F
NL
9.4 CYCLE COUNTER
Push Program button
➁
again.
The display will show alternately "P" or the number of wash cycles.
In the lower D
isplay
➃
appears the value up to 999.
Thousands will be shown in the upper Display ➄.
Example: 1023 wash cycles
Max. indication: 999 999
9.5 WATER CONSUMPTION COUNTER
Push Program button
➁
again.
The display will show alternately "E" or the water consumption (liter).
In the lower D
isplay
➃
appears the value up to 999 liter.
Thousands will be shown in the upper Display
➄
.
Example: 10217 liter
Max. indication: 999 999
9.6 REMAINING WATER QUANTITY COUNTER
FOR EXTERNAL WATER TREATMENT
Only available if activated in service mode (S18). The capacity
(liter) of the water treatment has to be stored via C79/80.
Push Program button
➁
again.
The display will show alternately "d" and/or the remaining water quantity
(liter).
In the lower D
isplay
➃
appears the value up to 999 liter.
Thousands will be shown in the upper Display
➄
.
Example: 1586 liter
Max. indication: 999 999
To reset the counter to pre-set value, push and hold (3 seconds) the
ON
/OFF button
➀
.
9.7 TERMINATION OF SETTING MODE OR
COUNTER DISPLAY
Close the door, open and close it again or do not press any
button for 10 seconds.
–
–
–
–
–
–
SETTINGS AND COUNTER VALUES