When setting the re, turn the locking all the way to the right (ECO 60).
If necessary, leave the door ajar for 10 minutes. Do not open the door wide,
as the window will remain cold. If the door is shut during this time, smoke will
condense on the glass and form soot. Move the air supply slider all the way to
the right “ + ” only when starting the re.
Prevent white glow and over-ring.
6.3. INSTRUCTIONS WHILE STOKING
After approx. 10 minutes, the re will be burning ercely. You can now top it up
with a few larger blocks of wood. Turn the locking all the way to the left (ECO 60)
when these blocks are burning well, and close the door.
Using the air supply slider you can now adjust the air supply for further
combustion. Make sure the re burns quietly.
Note: Once you have got the re going, leave the air supply slider in the centre
position for optimal combustion. Your re will then be much cleaner and more
efcient (more heat, less topping up).
Combustion air supply slider
Control range of primary air supply (by grate)
Control range of secondary and tertiary air supply
Centre position
ECO 60 / ECO 70
To Next Page
Loading...