8
Spectro LFP RT - Operating Manual
Chapter 2: Installation
2.1 Installing the USB driver software
If you use the USB connection, you need to install the USB driver on
your computer before connecting the instrument to the computer.
2.1.1 Installing on a Mac computer under OS X
Switch off the Spectro LFP.
Insert the supplied CD-Rom into your computer, run the "Barbieri
Gateway software installer" or the "USB Driver Installer program" on
the CD and follow the instructions.
Check if driver is correctly installed
• Switch on instrument
• Open “System Information” (About this Mac/ More info...)
• Show the “System Report” and check “Hardware/ USB”. The
instrument “Spectro LFP” must be listed
To Next Page