9
Spectro LFP RT - Operating Manual
2.1.2 Installing on a PC with Microsoft Windows XP or newer
There are two drivers to be installed for the connection between your
computer and Spectro LFP:
A. High speed USB to serial converter
B. USB virtual serial port driver
Switch off the Spectro LFP.
Insert the supplied CD-Rom into your computer, run the "Barbieri
Gateway software installer" or the "USB Driver Setup program" on the
CD and follow the instructions.
The installation procedures are guided automatically by an installation
wizard.
Check if driver is correctly installed
• Switch on instrument
• Open “Control Panel”, “System”
• Select “Hardware” and click “Device Manager”.
• Look into “Ports” and “Universal Serial Bus controllers”.
To Next Page