R5906018-03 EC Series6
1.1 General considerations
General safety instructions
• Before operating this equipment please read the EC series controller User Guide thoroughly and retain it
for future reference.
• All warnings in this documentation manual should be adhered to.
• All instructions for operating and use of this equipment must be followed precisely.
• All local installation codes should be adhered to.
Battery caution (EC-200/EC-210 only)
Partially based on a microcomputer, the EC-200 and EC-210 controllers need a CMOS battery to store BIOS
settings in memory.
CAUTION: Risk of explosion when the battery is replaced by an incorrect type. Dispose of used batteries
according to the waste instructions.
ATTENTION : Risque d'explosion en cas d'usage d'une batterie non prévue pour cet appareil. Jetez les
batteries usagées suivant les règles de recyclage prévues.
WARNING: Ensure you understand and follow all safety guidelines, safety instructions, warnings
and cautions mentioned in the product documentation.
WARNING: The mains power plug connected to the wall outlet must be easily accessible at all
times for all installation modes.
Environment
Do not place this equipment on an unstable cart, stand, or table. The product may fall, causing serious
damage to it.
1.2 Important safety instructions
To prevent risk, personal injury and EC series controller damage
Please read this chapter carefully. It contains important information to prevent personal injury while installing
the EC series controller. Furthermore, it includes several cautions to prevent damage to the device. Ensure
that you understand and follow all safety guidelines, safety instructions and warnings mentioned in this
chapter before installing the EC series controller. After this chapter, additional “warnings” and “cautions” are
given depending on the installation procedure. Read and follow these “warnings” and “cautions” as well.
• Read these instructions.
• Keep these instructions.
• Heed all warnings.
• Follow all instructions.
• Only trained technicians may install a EC series controller.
• Installation of the EC series controller must be done in a dust free area.
• Only use attachments/accessories specified by the manufacturer.
• CAUTION: Troubleshooting must be performed by a trained technician. To reduce the risk of electrical
shock, do not attempt to service this equipment unless you are qualified to do so.
• Refer all servicing to qualified service personnel. Servicing is required when the system has been
damaged in any way, such as liquid has been spilled or objects have fallen into the system, or the system
has been exposed to rain or moisture, does not operate normally, or has been dropped.
• FRAGILE: The EC series controller is fragile. Handle the unit with care at all times.
• To prevent injury, take note: by law, minimum 2 persons are required to carry the EC-200 and EC-210
controllers.
Safety guidelines
To Next Page
Loading...
