baridi DH13.V2 - Product Introduction; Product Specifications; Installation and Setup; Operating the Fridge

3
household and similar applications such as
staff kitchen areas in shops, ofces and other
working environments; holiday homes, hotels
and other residential settings; and catering
and similar non-retail applications.
• This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of knowledge and
experience if they have been given supervision
or instruction concerning the use of the
appliance in a safe way and understand the
hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without
supervision.
• INTRODUCTION
• Premier 80 litre capacity under-counter fridge
using direct compressor cooling technology
to give a temperature range between 3-10°C.
Built-in thermostat to control temperature to
user’s preference. Automatic defrost feature
tted to make using this device as easy and
convenient as possible. Design features three
strong removable wire rack shelves, internal
lament bulb and built-in security lock. Fitted
with a reversible glass door to make it even
easier to t in any space. Energy Efciency
Class E.
• SPECIFICATION
• Model no: DH13.V2
• Temperature range: 3-10°C
• Rated current: 0.6A
• Voltage: 220-240V
• Frequency: 50Hz
• Lamp power: 10W
• Energy efciency class: E
• Noise level: 42dB
• Dimensions (W x D x H): 474 x 440 x 840mm
• Volume:80L
• Energy consumption kWh per 24hours: 0.352
• Power consumption in Watt: 144
• INSTALLATION
• The unit is designed to be free-standing.
• Ventilation Space - a minimum space of 50mm
is required for the rear of the fridge and 30mm
for the top and both sides. This will maximise
the efciency, performance and the life of the
fridge and also ensure that there is sufcient
space for the hinge to operate effectively.
• Locate the unit away from direct sunlight or
sources of heat i.e. radiator, stove etc. Extreme
or cold ambient temperatures may also
prevent the unit working effectively.
• DO NOT locate the unit in a damp or moist
location.
• Ensure that the oor surface is strong and
stable enough to support the unit when it is
fully loaded.
• Level the unit when in location by using the
adjustable levelling feet in each corner.
• Once in position allow the unit to rest for an
hour before turning it on.
• Allow the unit 2-3 hours to reach set
temperature after switching on before placing
any items in the compartment.
• The unit is capable of having the door opening
handed.
• To change door opening, carefully remove the
door upper hinge cap using a at blade.
• Loosen the three cross head screws, remove
the hinge and lift off door.
• Remove lower hinge bracket and replace with
front foot from the other side.
• Remove hinge hole plug and place into
opposite side.
• Loosely x the lower hinge bracket to its new
position and carefully locate door in place.
• Loosely x upper hinge in place.
• Check that the door is properly closed, sealed
and level before tightening all screws.
• OPERATION
• The temperature control dial is accessed
inside the unit in the upper right corner.
• To turn the unit on, rotate control knob from
the O (off) position.
• Rotate control knob to the required value .
A setting of ‘5’ will create maximum cooling
effect (approx. 3
0
C) and ‘1’ will set working
internal temperature as approximately 10
0
C.
• When the set temperature is reached, the
compressor will stop working.
• On rst use, set the temperature to maximum
e.g. ‘5’ and adjust to suit once this is reached.
• Use the rocker switch close to the control
knob to turn on the unit’s internal light.