5
• Slide the bulb cover back into the slot until you
hear a ‘click’ (Fig. 5)
• Connect the unit back up to the power supply,
switch on and test.
• TROUBLESHOOTING
Fig. 5
Symptom Solution
Unit does not operate. Not plugged in.
Fuse/circuit breaker failure.
Turns on and off frequently.
Poor cooling.
Room temperature higher than normal.
Door opened too often.
Door not properly closed.
Temperature control incorrectly set.
Door gasket not sealing.
Not enough space around unit.
Vibrations Check to assure unit is level.
Noisy unit Contraction/expansion of panels.
Unit not level.
Check fan operation.
Check heat pump.
Door will not close properly Unit not level.
Gasket distorted.
Internals out of position.
To Next Page
Loading...