baridi DH238 - Page 3

3
• CAUTION:riskofre/Flammablematerials
• The refrigerant isobutene (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of
 environmentalcompatibility,whichisneverthelessammable.Duringtransportationandinstallationoftheappliance,ensurethatnoneof
the components of the refrigerant circuit becomes damaged.
• If the refrigerant circuit should be damaged:
•  Avoidopenamesandsourcesofignition.
• Thoroughly ventilate the room in which the appliance is situated.
•  Theplugmustberemovedbeforecleaning,maintainingorllingtheappliance.
8 DO NOTupendthisproductorinclineitovera45℃angle.
• To protect against risk of electric shock, do not pour water on: cord, plug or ventilation openings, immerse the appliance in water or any
other liquid.
• Unplug the appliance after using or before cleaning.
• Keep the appliance 8cm from other objects to ensure the good heat dissipation.
8 DO NOT use the accessories which are not recommended by Manufacturer.
8 DO NOT usetheapplianceneartoopename,hotplatesorstoves.
8 DO NOT switch on the power button frequently (ensure 5 min. interval at least) to avoid damaging the compressor.
• DO NOTinsertmetalorotherobjectsintotheappliancetoavoidreandshortcircuit.
• When removing the ice cream, do not knock the barrel or edge of barrel to protect the barrel from damage.
8 DO NOT switch on the power before installing the barrel or blender blade.
•  Thestartingtemperatureoftheingredientsis20±3℃.Donotputtheingredientsintofreezerforpre-freeze,asitwillmaketheblender
blade block before the ice cream has been made.
8 DO NOT remove the blender blade when the appliance is working.
8 DO NOT use outdoors.
• Never clean with scouring powders or hard implements.
• There are two round metal contacts on the transparent lid, (on the upper cover). When using, wipe away water on the transparent cover
and on the contacts in the body.
• When the machine is in use, the two contacts need to be dry because water presence will lead to power failure of the motor. Disconnect
from mains supply, wipe out the water, and restart the appliance.
Features