The Baridi 12 Bottle Wine Cooler/Fridge, Model No. DH4, is a sleek and compact appliance designed for storing wine at home. It features digital touch screen controls, an LED light, and an Energy Class A rating.
Function Description:
This wine cooler is designed to store up to 12 bottles of wine, maintaining a stable temperature range between 10-18°C. It utilizes thermoelectric cooling, which eliminates humming, uses less electricity, and causes less vibration, making it ideal for a home environment. The tempered mirror glass door reflects UV light, helping to protect the wine from degradation. The unit is intended for household and similar applications, including staff kitchen areas, holiday homes, hotels, and other residential settings.
Important Technical Specifications:
- Model No.: DH4
- Capacity: 12 bottles
- Max. Bottle Height: 315mm
- Volume: 32L
- Temperature Range: 10-18°C (Recommended ambient temperature up to 25°C)
- Power Rating: 65W
- Voltage: 230V
- Frequency: 50Hz
- Energy Consumption: 0.33kWh/24h
- Energy Efficiency Class: A (33bD)
- Noise Level: 33dB
- Plug Type: BS1363/A 13 Amp 3 pin plug
- Replacement Fuse Rating: 13A
Usage Features:
- Digital Touch Screen Control: The unit features a digital touch screen for easy temperature adjustment and control.
- Automatic Lockout: The control panel automatically locks out after 20 seconds of non-use. To unlock, hold the unlock symbol for approximately 2 seconds until an audible noise is emitted.
- Internal LED Light: The internal light can be turned on by pressing the light symbol and will automatically turn off after 10 minutes.
- Temperature Unit Change: To change the displayed temperature units (e.g., Celsius to Fahrenheit), press and hold the temperature unit symbol for approximately 2 seconds.
- Temperature Setting: Use the up and down arrow symbols to increase or decrease the desired operating temperature. Each press adjusts the value by 1°C.
- Free-standing Design: The unit is designed to be free-standing.
- Ventilation Space: A minimum space of 20mm is required for the rear and top, and 30mm for both sides, to maximize efficiency and performance.
- Leveling: The unit should be leveled using the adjustable leveling feet in each corner.
- Initial Setup: After positioning, allow the unit to rest for an hour before turning it on. Allow 2-3 hours for the unit to reach the set temperature before placing items inside.
- Placement: Locate the unit away from direct sunlight or heat sources. Avoid damp or moist locations. Ensure the floor surface is strong and stable enough to support the unit when fully loaded.
Maintenance Features:
- Cleaning: Always remove the power plug from the supply before performing cleaning or maintenance.
- Exterior and Interior Cleaning: Wipe interior and exterior surfaces with a damp cloth and dry thoroughly with a clean, dry cloth. For more soiled surfaces, use a neutral detergent, then wipe down with a clean damp cloth and dry thoroughly.
- Prohibited Cleaning Materials: DO NOT use abrasive or chemical cleaning materials on any surface of the unit.
- Electrical Safety Checks: Regularly inspect power supply cables, plugs, and all electrical connections for wear or damage. Ensure the insulation on all cables is safe. Any faulty item should be repaired or replaced immediately by a qualified electrician.
- Fuse Replacement: If the cable or plug is damaged, replace the damaged plug with a BS1363/A 13 amp 3 pin plug.
- General Safety: DO NOT store explosive substances in the appliance. Ensure the supply cord is not trapped or damaged. Avoid locating multiple portable socket-outlets or power supplies at the rear of the appliance.
Troubleshooting Guide:
- Unit does not operate: Check if it's plugged in, or if there's a fuse/circuit breaker failure.
- Turns on and off frequently/Poor cooling: Could be due to high room temperature, door opened too often, door not properly closed, incorrect temperature control setting, door gasket not sealing, or insufficient space around the unit.
- Vibrations: Check to assure the unit is level.
- Noisy unit: May be caused by contraction/expansion of panels, unit not being level, fan operation, or heat pump.
- Door will not close properly: Check if the unit is level, if the gasket is distorted, or if internals are out of position.
Environmental Protection:
The product should be disposed of in an environmentally friendly way at the end of its useful life, in accordance with Waste Electrical and Electronic Equipment (WEEE) regulations. Any fluids (if applicable) should be drained into approved containers according to local waste regulations.
To Next Page
Need help?
General
