baridi DH49 - INTRODUCTION; SPECIFICATION; INSTALLATION; OPERATION

3
• DO NOT remove CO
2
cartridge until fully empty.
• DO NOT cover the unit while working.
• DO NOT place in direct sunlight.
• WARNING: Ensure the supply cord is not
trapped or damaged.
• WARNING: This appliance is intended
• This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of knowledge and
experience if they have been given supervision
or instruction concerning the use of the
appliance in a safe way and understand the
hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without
supervision.
• INTRODUCTION
• Universal tting for all 5L beer kegs.
Thermoelectric cooling technology chills beer
to as low as 4°C. Keeps beer fresh for up to 30
days. Removable drip tray with raised lip helps
prevent spillage. LED temperature gauge.
Operates using standard 16g CO
2
canisters.
Modern stainless steel and black design.
• SPECIFICATION
• Model no: DH49
• Lowest temperature: 4°C
• Rated current: 0.76A
• Voltage: 220-240V
• Frequency: 50Hz
• Noise level: ≤38dB(A); Ambient noise ≤25dB(A)
• Dimensions (W x D x H): 335 x 460 x 470mm
• Keg capacity: 5L
• INSTALLATION
• DO NOT locate the unit in a damp or moist
location.
• Operate unit on dry and level surface.
• NOTE: The unit is designed to be free-standing
and to ensure adequate ventilation, leave at
least 12 cm free space around the unit.
• Once in position allow the unit to rest for an
hour before turning it on.
• OPERATION
• Read this document thoroughly and assemble
the unit accordingly.
• Check that the unit is fully assembled and
installed in the appropriate location.
• Ensure that CO
2
valve is fully closed.
• Locate drip tray (g.1) into body and make
sure that the drain switch (g.1) is set in the
off (upright) position.
• Carefully pour 800 ml of clean tap water into
the cooling cavity.
• DO NOT exceed the ‘MAX’ mark inside the
chamber when lling.
• Select a temperature setting using the LED
interface on the top of the unit (g.1).
• NOTE: The LED display shows the current
temperature of the beer and pressing
and holding the ‘+’ key displays the set
temperature.
• Allow the unit time to reach the set
temperature before placing keg into the
cooling compartment.
• If using a ‘universal’ beer keg, open the
pressure control valve (g.1) and gently pull
the tap handle to begin ow.
• Use the pressure control valve to control the
beer’s ow rate and level of frothing.
• If serving Heineken beer, ensure the pressure
control valve is fully closed as the kegs have
their own internal pressurising device hence
there is no need to use the gas.
Pressure
Control
Drain
LED
Display
Drip tray
Latch
Fig.1