10
05-2021
14
A Apply high temperature silicone to
the tops of the firebrick as well as
to the quarry stone supports on the
front.
B Install the Firecap on top of firebrick
as indicated in the diagram.
USE:
Firecap
15
A Place the spark arrestor at the top of
the fireplace setup as shown.
USE:
Spark Arrestor
13
A This shows how the fireplace will
look when all the firebricks installed.
Warning: Only use Silicone when
securing the Fire Brick. Allow Silicone to
set 2 hours before installing the Firecap.
To Next Page
Loading...