Caution
Be sure ambient temperature does
not exceed 40°C (104°F). The rec-
ommended ambient temperature is
17°C - 27°C. Ambients above this
level may result in damage to the
controller.
Caution
Allow at least six inches of space
between the furnace and any com-
bustible surface. This permits the
heat from the furnace case to
escape so as not to create a pos-
sible fire hazard.
Warning
To avoid electrical shock, this fur-
nace must always use a properly
grounded outlet of correct voltage
and current handling capacity.
Site Selection
Install furnace on a sturdy surface and allow
adequate space for ventilation.
Electrical Connections
The electrical ratings are located on the spec-
ification plate on the back of the furnace.
Consult Barnstead/Thermolyne if your electri-
cal service is different than those listed on the
specification plate. Be sure the front power
switch is in the OFF position before connect-
ing the furnace to your electrical supply.
To Next Page
Loading...
