30SG OPERATOR’S MANUAL 11/25/13 Page 8 of 24
CONTROLS (continued)
4. CUTTER WHEEL CONTROL: To start the cutter wheel, hold down the thumb button on the control
handle. Then pull the trigger back. After the wheel is started, the thumb button can be released, but the
trigger must be held to keep the cutter wheel turned on. To raise the cutter head, pull the control handle
back. Push the control handle forward to lower the cutter head. The cutter head is moved to the left and
right by leaning the control lever left or right.
TRIGGER THUMB BUTTON
5. PARKING BRAKE: It is located behind the left hand track motor. Move the handle down to engage the
brake, and up to disengage it.
To Next Page
