General information Operating instructions – SILAS control unit
Subject to technical changes
6 / 48 A1-3741-7D0001 / Rev-G-04-2024 / ESS-294266
1
General information
1.1
Manufacturer
Max-Eyth-Strasse 16
97980 Bad Mergentheim
Germany
Fax: +49 7931 597 119
Internet: bartec.com
Email: info@bartec.com
1.2
Purpose of these operating instructions
Please read the enclosed operating manual carefully before starting up the SILAS
control unit.
These operating instructions contain the required information for the intended use of the SILAS
control unit.
The operating instructions are intended for those individuals who are qualified to assemble, install,
start up and maintain the product.
They are addressed to technically qualified personnel. The operating instructions are an integral
part of the product. They should always be kept in the immediate vicinity of the device and
accessible to the installation, operating and maintenance personnel.
If applicable, the guidelines and standards for areas with gas atmospheres must be observed
before starting any work, e.g.: RL 2014/34/EU, EN / IEC 60079-17 and EN / IEC 60079-19.
Knowledge and technically correct implementation of the safety instructions and warnings
described in these operating instructions are a prerequisite for safe installation and
commissioning. The safety instructions and warnings in these operating instructions are kept
general and only qualified personnel have the necessary knowledge to interpret and implement
them correctly in specific individual cases.
These operating instructions are an integral part of the scope of delivery, even if they can be
ordered and delivered separately for logistical reasons.
- If you require any further information, please request it from your local or responsible BARTEC
subsidiary. Please read the operating instructions and, in particular, the safety instructions
carefully before using the device.
- Keep the operating instructions for the entire service life of the device.
- Make the operating instructions available to all persons entrusted with handling the device.
1.3
Languages
The original user manual is written in German. All other available languages are translations of the
original user manual.
The user manual is available in German and English. If there are any other languages which are
required, these must be requested from BARTEC or specified when ordering.
To Next Page
Loading...
Need help?
General
