Operating instructions – SILAS control unit General information
A1-3741-7D0001 / REV-G-04-2024 / 294266 7 / 48
Subject to technical changes
1.4
Technical changes
BARTEC reserves the right to change the contents of this document without prior notice. No
guarantee is given for the correctness of the information. In case of doubt, the German safety
instructions apply, as translation and printing errors cannot be ruled out. In the event of any legal
dispute, the “General Terms and Conditions” of the BARTEC Group shall apply in addition.
1.5
Additional documents
The current versions of data sheets, operating instructions, certificates and EC Declarations of
Conformity as well as information on accessories can be downloaded from www.bartec.com or
requested directly from BARTEC GmbH.
1.6
Conformity to standards and directives
For certificates and EU Declaration of Conformity, please see www.bartec.com.
1.7
Explanation of the individual markings
1.7.1
Markings in the operating instructions
DANGER
This symbol indicates a hazard that will result in death or serious injury if not avoided.
WARNING
This symbol indicates a hazard that can result in death or serious injury if not avoided.
CAUTION
This symbol indicates a hazard that may result in injury if not avoided.
ATTENTION
This symbol indicates measures to avoid damage to property.
Note
This symbol indicates important notes and information on effective, economical and
environmentally friendly handling.
1.7.2
Markings on the device
CE marking according to the currently valid directive.
Device certified in accordance with the marking for potentially explosive atmospheres.
Marking according to WEEE directive 2012/19/EU
To Next Page
Loading...
Need help?
General
