Barton 99806 - Operation and Maintenance; Intermediate Spin; Soak Rinse; Maintenance

5
OPERATION and MAINTENANCE MAINTENANCE and TROUBLESHOOTING
INTERMEDIATE SPIN (REMOVING DETERGENT/DRY):
1. Move the laundry from the WASH tub to the SPIN tub.
2. Spin to remove dissolved detergent. Be sure to arrange laundry uniformly without
stacking them all on one side. Press the laundry down rmly and place the safety cap
on top of them.
3. After rinsing, close the outer cover of the spin tub and spin for one minute.
NOTE: An unbalanced spin tub may cause abnormal vibrations or noise. If this occurs,
open the cover and rearrange the laundry, then ontinue the spinning operation.
SOAK RINSE:
1. Place laundry into the wash tub, then select the suitable wash type. Select the water level (according to the
amount of laundry). RINSE, set the timer to 0-5 minutes and let it rinse.
2. DRY SPIN: Arrange the laundry uniformly in the spin tub (do not stack on one side). Press the laundry
down rmly and place the safety cover on top of them. Select a suitable spinning duration according to the
quantity of laundry. 1-5 minutes.
Unplug the power supply before performing and disposal. There will be lint left behind in the overow
lter and the lint lter after every use. These lters need to be cleaned frequently in order to maintain
the performance of this machine.
Clean the entire machine with a damp, soft cloth. DO NOT spray water directly into the machine. If the
machine is too dirty, add neutral detergent to clean it. DO NOT use petroleum based detergent to clean the
machine, this will affect the appearance.
CLEANING THE OVERFLOW FILTER:
1. Dismanteling the Overow Filter: Pinch the exible-fastening claw, pull it gently away from the machine
as shown. Do this at least once every two months.
2. Dismanteling the Bellows: Dismantle the top of the pipe in the overow lter.
3. Cleaning the Overow Filter: Clean the lter completely under running water.
4. Installing the Overow Filter: Install the bellows, then insert the tie plate of the bottom valve cover. Put
the hook at the top left. Press the top to the slot as shown in the picture. Clean the lint lter.