- 32 -
5.2 Operation
Preparation
• Before you start using the unit read the instruction manual to know the unit and its
accessories.
• Before you start using the unit clean it thoroughly following the instructions in point
6.2 “Cleaning“.
• Shut the glass cover.
• Plug in the unit to the correct, single socket. Turn the unit on with ON/OFF switch
(set at “I“).
• The digital display will show the set temperature and the LED cooling
indicator will light.
• You should place the food in the refrigerated cabinet only when the unit reaches
its operational cooling parameters.
Set the required temperature (required value)
• Optimal temperature is set as default and corresponds to the operational
temperature inside the refrigirated cabinet between 0 °C and 10 °C.
• To set or change the required value:
press , and the set value starts flashing on the digital display;
increase or decrease the temperature as required with or buttons;
save the set temperature with button.
NOTE!
Unless you press any button in the 10 following seconds the digital
display shows the temperature inside the refrigerated cabinet.
The displayed temperature is the value measured in the close proximity to the
temperature probe and serves controlling the cooling.
To Next Page
Loading...