6
Operation steps
1) Insert the smart ignition clip into the EC5 port of the jump starter. The indicator of
the smart ignition clip blinks red and green alternately.
2) Clip the smart ignition clip to the car battery (the positive terminal of the smart
ignition clip to the car battery, the negative terminal of the smart ignition clip
corresponds to the negative terminal of the car battery).
3) When the green LED indicator of the smart ignition clip is steady on, the car can be started.
*NOTE:
1) Do not start the car continuously. The start interval should not exceed 5 s, and
the second start needs an interval of longer than 30 s.
2) To protect the battery, remove the jump starter immediately after starting the car.
Lamp description
Press and hold the power button for 3 s to turn on or off the flashlight function. When
the flashlight is on, press the power button to switch between steady on, SOS, and
blinking mode.
To Next Page
Loading...