Declaration of Conformity
Shenzhen Baseus Technology Co., Ltd. Declares that the product is in compliance with Directive 2014/53/eu. The full text of
the EU declaration of conformity is available at the following internet address:
https: //eu.baseus.com/pages/euro-compliance.
S0ST00
S1UA00
Wi-Fi 2412-2472MHz EIRP 18.07dBm
Wi-Fi 2412-2472MHz EIRP 17.26dBm
Model Function Operation Frequency Max. RF Power
RF exposure notice:
The Maximum Permissible Exposure(MPE)level has been calculated based on a distance of d=20cm between the device and
the human body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm distance
between the device and human body. Frequency bands and power are as below:
9.Safety
This symbol indicates that this product shall not be treated as household waste. Instead, it shall be
handed over to the applicable collection point for the recycling of electrical and electronic equipment.
Follow local rules and never dispose of the product with normal household waste.
FCC Statement
This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in fixed/mobile exposure
condition. The min separation distance is 20cm.
The following importer is the responsible party (for FCC matters only)
Company Name: BASEUS TECHNOLOGY (US) INC
Address: 421 S BROOKHURST ST SUITE 1312
АNAHEIM, СА 92804
Telephone: +6-145412699
06
This product complies with the radio interference requirements ofthe European Community.
To Next Page
Loading...