BASIC-FIT ICR-BF - Setup and Usage; Before You Begin; Location and Moving; Leveling and Proper Usage

6 7
ENGLISH
1
Hardware Qty
A
B
C
Bolt (M8x20L)
Flat Washer (M8)
Arc Washer (M8)
7
5
2
3
Hardware Qty
F
G
H
Screw (remove and discard)
Screw (M4x10L)
Flat Washer
2
2
2
ASSEMBLY COMPLETE
LEVELING THE BASIC-FIT CYCLE
It is extremely important that the levelers are correctly adjusted
for proper operation. Turn leveling foot clockwise to lower and
counter-clockwise to raise unit. Adjust each side as needed until the
Basic-Fit Cycle is level. An unbalanced Basic-Fit Cycle may cause
belt misalignment or other issues. Use of a level is recommended.
BEFORE YOU BEGIN
LOCATION OF THE BASIC-FIT CYCLE
Place the Basic-Fit Cycle on a level and stable surface away from direct sunlight. The intense UV light can cause
discoloration on the plastics. Locate your Basic-Fit Cycle in an area with cool temperatures and low humidity.
Please leave a clear zone on all sides of the Basic-Fit Cycle that is at least 60 cm (2 ft).
This zone must be clear of any obstruction and provide the user a clear exit path from the Basic-Fit Cycle.
Do not place the Basic-Fit Cycle in any area that will block any vent or air openings.
MOVING THE BASIC-FIT CYCLE
Your Basic-Fit Cycle has a pair of transport wheels built into the front stabilizer tube. To move, firmly
grasp the steel portion of the rear stabilizer tube, carefully lift and roll on the transport wheels.
WARNING!
The Basic-Fit Cycle is heavy, use care and additional help if necessary when moving.
Failure to follow these instructions could result in injury.
PROPER USAGE
1. Sit on the Basic-Fit Cycle facing the
handlebars. Both feet should be on the
floor one on each side of the frame.
2. To determine proper seat position, sit
on the seat and position both feet on the
pedals. Your knee should bend slightly at
the furthest pedal position. You should be
able to pedal without locking your knees
or shifting your weight from side to side.
3. Adjust pedal straps to desired tightness.
4. To get off of the Basic-Fit Cycle, follow
the proper usage steps in reverse.
ENGLISH
FREE AREA
0.6 m (2 ft)
Torque Value
30 Nm / 22 lb-ft.
2
Hardware Qty
D
E
Bolt (M6x15L)
Flat Washer (M6)
6
6
Torque Value
12 Nm / 9 lb-ft.
4
Hardware Qty
D
E
I
J
Bolt (M6x15L)
Flat Washer (M6)
Bolt (M6x20L)
Screw (M4x12L)
2
4
2
3
A
B
C
B
B
A
A
D
E
F
G
H
J
E
I
D