9
M
A
INTENANCE – cont.
D
aily Maintenance and Inspections
1
. Clean dirt, gravel, and debris from all moving parts on this machine.
This includes steering king pin, as well as and inspection of collected
material on and around the tires and wheels and between the tires and
gear boxes.
2. Grease the front steering pin, as well as the upper and lower
oscillation pins.
3. Grease the gear box oscillation located on the front and rear of each
gear box.
4. Service the engine according to the recommendations of the Engine’s
Daily Service Manual.
5. Check Hydraulic Fluid Level, Fuel Level, Oil Level, and Water Level.
6. Inspect and replace coco mat if necessary.
First 50 hours (break in period)
1
. Service the engine according to the recommendations of the Engine’s
Daily Service Manual.
2. Check the hydraulic fluid level and change hydraulic system filters.
Monthly or 150 hour Maintenance and Inspections
1
. Service the engine according to the recommendations of the Engine’s
Daily Service Manual.
2. Check hydraulic fluid level and change hydraulic system filters.
3. Inspect the entire machine for loose bolts, leaking hoses, hose wear
metal fatigue, and loose belts.
4. Inspect the tires for cuts or chips on the rolling surface and check air
pressure.
5. Lubricate the forward and reverse linkage using WD40 or a similar type
aerosol lubricant.
Yearly or 400 hour Maintenance and Inspections
1
. Check for wear of brass bushings in the front steering oscillation pins,
the steering king pin and the gear box oscillation pins. Replace if
necessary.
2. Grease all 4 axle bearings. This is done only once each year and this
requires only a small amount of grease. (Too much grease may cause
seal damage and this will allow dirt to enter the bearing and destroy
it.) Two shots of grease per bearing is sufficient.
3. Inspect and adjust chain tension in gear boxes.
To Next Page
Loading...
Need help?
General