Basler 4C-1.25A84W-24V - User Manual

Basler Light Controller 4C-1.25A-
84W-24V# 2200001189
The Basler Light Controller 4C-1.25A-84W-24V allows you to use any Basler Standard
Light as well as any other light device in your environment.
If you directly connect the lights to the controller, you can specify the output current supplied
to the light which in turn controls the brightness. Alternatively, you can use a camera as an
external trigger source allowing you to turn the light on or off.
Specifications#
General Specifications#
Basler Light Controller 4C-1.25A-84W-24V
Input Voltage
100–240 VAC
Power Consumption
120 W (typically)
Driver Method
Constant-current system
Brightness Control Method
Manual (10 mA – 1.25 A) or via current limit
Communication Port
100/10 Mbps Ethernet (TCP/UDP IP)
Number of Channels
4
External Trigger Response
<50 µs
Protection
Short circuit protection
Over temperature protection
Current limit circuit
Channel 1–4 Output Voltage (Rate)
8–24 VDC
Channel 1–4 Maximum Output Current (per
Channel)
1.25 A
12 V Output Voltage (Rate)
12 VDC

Basler 4C-1.25A84W-24V Specifications