Need help?Do you have a question about the Basler BE2000E and is the answer not in the manual?
General| Model | BE2000E |
|---|---|
| Power Supply | 24 VDC (19.2 V - 30 V) |
| Dimensions | 175 mm x 120 mm x 50 mm |
| Operating System | Linux |
| Communication Interfaces | RS-232 |
| Storage | 32 GB eMMC |
| Connectivity | RS-232 |
Explains formatting conventions for safety and procedural information presented in the manual.
Lists the key features and capabilities of the BE2000E units.
Details the 12 red LEDs and three pushbuttons on the BE2000E front panel for mode and status indication.
Step-by-step guide for performing initial setup and adjustments on the BE2000E before generator operation.
Description of the internal function blocks of the BE2000E, including inputs, outputs, and processing units.
Details the analog voltage/current inputs and four contact input circuits for system interface.
Describes the RS-232 port for programming and the BESTCOMS software connection.
Guidance on mounting the BE2000E unit and making the necessary electrical connections.
Steps for initial setup, including wiring, power connection, and preliminary adjustments before generator operation.
Instructions for installing the BESTCOMS software and launching the BE2000E application.
Procedure for establishing communication and managing settings between PC software and the BE2000E.
Recommendations for periodic checks to ensure the BE2000E and system connections are clean and tight.
Diagnostic steps for common problems like voltage build-up failure, low/high voltage, and unstable output.
Details electrical specs for power, sensing, output, protection, and operating modes.
Information on operating environment, type tests, UL/CSA/CE compliance, and physical weight of the BE2000E.
To Next Page
