9287500995 Rev B 19
Installation
The BE2000E is delivered in a sturdy carton to prevent shipping damage. Upon receipt, check the part
number against the requisition and packaging list for agreement. Inspect for damage, and if there is
evidence of such, immediately file a claim with the carrier and notify your sales representative or a sales
representative at Basler Electric.
If the unit is not installed immediately, store it in the original shipping package in a moisture- and dust-free
environment.
Mounting
The BE2000E is normally located in the generator conduit box. It is designed for behind the panel
mounting and requires a cutout for front panel viewing and access. Mounting hardware consists of six
customer supplied, #12 thread-forming screws that pass through mounting holes in the conduit box and
thread into the plastic shell of the BE2000E. The unit must be mounted where the ambient temperature
does not exceed the allowable environmental conditions called out in the General Information chapter.
BE2000E package dimensions are shown in Figure 4. Cutout and drilling dimensions are shown in Figure
5.
BE2000E Installation
To Next Page
Loading...
Need help?
General
