Basler BE2000E User Manual

9287500995 Rev B 3
Human-Machine Interface
The BE2000E Human-Machine Interface (HMI) consists of front panel controls and indicators and a rear
panel communication port.
Front Panel Controls and Indicators
BE2000E front panel controls and indicators consist of 12 red LEDs and three pushbuttons. Figure 1
illustrates the front panel controls and indicators of the BE2000E. The LEDs indicate control mode and
status conditions and are also used when adjusting settings at the front panel.
Figure 1. BE2000E Front Panel Indicators
Table 1. BE2000E Front Panel Control Descriptions
Control Description
SELECT
This pushbutton selects a function for adjustment. Successive presses of
the SELECT pushbutton scrolls through the list of BE2000E functions to
be adjusted.
UP
This pushbutton increases the setting level of the function being adjusted.
DOWN
This pushbutton decreases the setting level of the function being adjusted.
UP
SELECT DOWN
Manual Mode
Loss of Sensing
Over VoltageCoarse Voltage
1 - 3 Phase Sensing
Manual Mode On/Off
2
1
3
Over Excitation
MODE STATUS
Over Temperature
Under Frequency
VAR/PF Active
If - Limit
Stability Range
Fine Voltage
ADJUSTMENTS
Manual Mode Adj.
VAR/PF Select
VAR/PF Adj.
Under Frequency
Droop
Gain
6
4
5
7
8
12
10
GEN/LAG
9
11
MAX
ABSORB/LEAD
MIN
Digital
R
Regulator
BE2000E
BE2000E Human-Machine Interface

Basler BE2000E Specifications

General

Brand	Basler
Model	BE2000E
Category	Controller
Language	English