1. Taking out the keyboard and USB cable, connecting the
keyboard to your computer. After the keyboard connecting to the
computer successfully, the computer will install the driver
automatically, and it will display the installation status at the bottom
right corner of the computer.
2. Default system: Mac OSX
Default mode: Keyboard mode
3. In Mac OSX system:
LED backlight is bright without touching,it turns dark after touching.
In Windows system:
LED backlight is dark without touching,it turns bright after touching.
4. The LED backlight will turn off after 5 minutes without touching, it
will turn on when touch it again.
5. Interruption of power supply saving status: system status, LED
status and LED backlight status feedback. Interruption of power
supply without saving status: function status (press mose key is
setting to touchpad, press keyboard key is setting to keyboard).
Fast Using Guide
A2
Close / Open LED backlight status feedback
Switching the backlight brightness feedback
Fn
Close / open LED backlight status feedback
Switching the backlight brightness feedback
To Next Page
Loading...