1312
EN EN
03 Turn on
This glo™ tobacco heater
has two heating modes:
‘Standard’ and ‘Boost’.
Standard is a normal smoking
session and lasts for 4 minutes.
Boost is a shorter but more
intense experience.
You can choose either Standard
or Boost mode when you start a session.
To choose a Standard Mode session:
Hold down the control button on the glo™ tobacco heater
for 3 seconds to start the heating process. The glo™ tobacco
heater will vibrate gently after these 3 seconds to indicate
that the session has been started and the control button
should be released. The first light on the control button will
begin to flash indicating a STANDARD session has been
selected. The lights will become solidly illuminated as the
device heats up.
After 20 seconds, all four lights on the glo™ tobacco heater
will be solidly illuminated and the glo™ tobacco heater will
vibrate gently to indicate that it’s ready to use.
To start a Boost Mode session:
Hold down the control button on
the glo™ tobacco heater for 5 seconds
to start the heating process. The glo™
tobacco heater will vibrate gently after 3 seconds, and then
again at 5 seconds to indicate a session has been started.
Release the control button after the second vibration.
The lights on the control button will begin to rotate to
indicate that BOOST has been selected. After 10 seconds,
all 4 lights on the glo™ tobacco heater will be solidly
illuminated and the glo™ tobacco heater will vibrate
gently to indicate that it’s ready to use.
STANDARD MODE: Light Display
20 seconds
15 seconds
10 seconds
5 seconds
Ready to use
BOOST MODE: Light Display
Ready to use
10 seconds
To Next Page
Loading...
