Questions? Visit BathRoyale.com or call (704) 589-1009
Installation Instructions
2
Important: Mounting surface of toilet must be at, clean and dry with no chemical residue. To prepare
mounting surface, we recommend using Windex® (or any glass cleaner) around the mounting holes of
the toilet to get the mounting surface squeaky clean.
1. Install mounting bases on toilet bowl.
a. Place mounting bases over holes with posts
facing the front of the bowl.
b. Insert screws through the mounting bases and
holes in the toilet.
Tip: Mounting bases rotate 360 degrees allowing
seat to be adjusted and t non-standard hole
spacings (4 ½ to 6 ½ inches).
1.
2. Install wing nuts. DO NOT turn wing nuts.
a. Hold screw down and push wing nut onto screw.
b. Thread wing nut by turning the screw (do not
turn wing nut).
Note: Wing nuts work on a wedge principle.
To function properly, the tips must be centered
in the underside of the mounting hole. If not
tightening, move wing nut around while pushing
upward until tips slip into the hole. As the screw
turns, the points of the wing nut are squeezed
tighter into the mounting hole.
Tip: Do not completely tighten. The mounting
bases must be able to move so the seat can be
attached (Step 4) and adjusted (Step 6).
Note: Industry standard mounting holes are round
and
5
/
8
inch (14 mm) in diameter. If your toilet holes
are not standard or the wing nuts will not thread,
please contact us. We have alternate mounting
hardware available.
2a.
(View from underside of bowl shelf)
2b.
To Next Page
Loading...
