Questions? Visit BathRoyale.com or call (704) 589-1009
Installation Instructions
3
3. Rotate mounting bases so the posts are
closest to the front of the bowl (not tank).
Using a tape measure or ruler, adjust the mounting
bases so the posts are approximately 5 ½ inches
apart (this is the distance between the mounting
holes in the seat). Loosen screws if necessary.
5. Close seat and lid.
Tap forward and let the seat and lid close by
themselves.
Tip: It is OK to push the seat and lid closed. Unlike
other Slow-Close seats, Bath Royale® seats can
be force-closed repeatedly, without damaging
the Slow-Close mechanism.
Closing too slow? Push it closed.
5
1
2
“
4.
3.
4. Attach seat (Quick-Release mechanism).
With mounting bases slightly loose, carefully lower
seat (holes) onto mounting posts. NOTE: If posts
are not perfectly aligned, move seat and mounting
base(s) so both posts can be inserted at the same
time (lift mounting bases to unstick from the bowl,
if necessary).
Tip: Push seat down and jiggle slightly, making
sure both posts are completely inserted.
5.
To Next Page
Loading...