Using your Hydropump in the Shower
1. Relax in the Shower for a few minutes.
2. Lock the valve by rotating the valve cap clockwise.
3. Push the black pip into the closed position with your nger,
remove the comfort insert (to prevent trapped air) then invert the
Hydropump under the shower head until full of water.
4. Replace the comfort insert.
5. Place the Hydropump over your accid penis tight up to your
pelvic seat with the black pip in the closed position. The
chamfer can be positioned facing either upwards or downwards
depending on your level of comfort.
6. Make a seal against your body, ensuring that the positioning is
comfortable and that your testicles are well clear.
7. With the Hydropump angled slightly upwards, open the valve
by pushing the black pip to the central position and commence
pumping.
8. Ensure that the black pip is in the central (open) position when
pumping.
9. Pump slowly and evenly until the bellows remain depressed,
indicating that optimal vacuum has been achieved.
10. To increase the vacuum further and for more control, use the
hand ball pump either with the hose or connected direct to
the pump. Please note, the t between the handball pump
and the Hydropump valve is designed to be a non permanent
connection. For this reason the handball should be held in
position whilst in use, and removed when optimum vacuum is
achieved. If a more permanent connection is desired, please use
the hose connector.
11. Ensure you follow the recommended instructions.
12. To remove the Hydropump, unlock the valve by rotating the
valve cap anti-clockwise and release the vacuum by depressing
the valve cap inwards to activate the quick-release mechanism
and slide the Hydropump o your penis.
To Next Page
Loading...