BATHMATE HYDROXTREME - Getting Started

GETTING STARTED
Recommended Use
In order to obtain optimum benet from the Hydropump and to avoid
inappropriate use which may cause discomfort, you are strongly
advised to follow the instructions as outlined below:
BEFORE FIRST USE: Wash your hydropump using warm, clean
soapy water and rinse thoroughly.
• Ensure your pubic area is reasonably well trimmed. This will
facilitate the vacuum seal against the pelvic seat.
• A relaxation period of a few minutes in a warm shower or bath is
required to allow the testicles to soften, allowing them to remain
free from the sealing area thereby avoiding any discomfort.
• Apply only the minimum amount of vacuum pressure necessary
to achieve an erection. Excessive vacuum pressure and over
vigorous pumping may result in bruising or injury to the penis.
• To benet the most in erection hardness and optimal blood ow, it
is best to remove the device every 2-3 minutes and allow the penis
to retract. Massage the penis in the accid state for 2 minutes,
then re apply the device and repeat the process. You should do
this a maximum of 3 times in any 15 minute session.
• Do not use the Hydropump for more than 15 minutes in any period
of 24 hours.
How the Hydropump works
The Hydropump functions by creating a vacuum seal against the
pubic area of the user, enclosing the accid penis. When the pump
is pushed downwards against the body, the bellows compress and
water is ejected from the end of the pump via the open valve. When
released the bellows expand and the valve closes, creating a partial
vacuum inside the pump. This causes the penis to expand and ll
with blood, creating an erection. Re pumping increases the vacuum,
and so increases the size of the erection.
The user controls the level of vacuum by depressing the valve
inwards against the spring, opening the valve and allowing air
or water back into the body of the pump, thereby partially or fully
releasing the vacuum.
The vacuum in Bathmate Hydropumps is created by the elastic
recoil strength of the bellows pump, so the user cannot exceed
the safe partial vacuum levels allowed under European and USA
medical regulations.
IMPORTANT
The black pip on the top of the valve is moved by pressing inwards
and moving to the right or left, where it should “click” into position
closing the valve. The closed position should only be used whilst
lling the Hydropump with water in the shower. At all other times
the black pip should be in the central (open) position. Failing to
ensure that the black pip is in the central position will prevent the
Hydropump from operating correctly.