BatteryMINDer
®
Model SCC180
Rev. E-052115 Page 13 P/N VDC SCC180-MNL
correctly allowed your battery to “rest”* after rst having fully charged it as
indicated above.
IMPORTANT NOTE: Fused lead (located on positive lead of battery
connector): ATC-15 blade type 15 amp rated. DO NOT ATTEMPT TO
BYPASS OR REPLACE WITH HIGHER RATED FUSE; SERIOUS DAMAGE
WILL OCCUR.
INSTRUCTIONS TEMPERATURE SENSOR Type:ABS-248
(At-the-Battery Sensor) (OPTIONAL)
If you purchased the optional At-the-Battery Temperature Sensor,
please read and fully understand all of the following before beginning
your installation.
If battery is being charged or maintained in temperatures as low as
32°F to a high of 125°F this sensor must be used.
Do NOT modify by extending or shortening the extension cord.
Your rst choice should be to connect it to the positive (+) or Negative (-)
post (clamp or screw) of the battery. This is the best location to sense the
temperature of the battery.
To Next Page
Loading...
