Battipav Super Pro 450

Questions and Answers

N
Nancy SmithAug 6, 2025
What to do if the cutting wheel on my Battipav Cutter does not cut correctly?
- A
  Andrew KnightAug 6, 2025
  If the cutting wheel on your Battipav Cutter isn't cutting correctly, there are a few potential reasons. First, the cutting wheel itself might be worn and needs replacement. Alternatively, the clamp on the cutting foot support could be worn, requiring replacement of the cutting foot. Finally, ensure the cutting wheel is adjusted correctly, as the screw on the cutting wheel support may have become loose.
J
Joseph CollinsAug 15, 2025
Why is the cutting carriage on my Battipav Super Pro 450 difficult to slide?
- B
  Brooke ScottAug 15, 2025
  If the cutting carriage on your Battipav Cutter is difficult to slide, it could be due to several factors. The carriage rod might be encrusted with cutting residue; if so, clean the rod and ensure the carriage is adjusted correctly. Alternatively, the carriage rod or the bearings on the cutting carriage may be worn, in which case you should contact your local dealer for replacement. Also, too much play on the tile cutter might be the issue; verify that the carriage is adjusted correctly.
C
Claudia AndersonAug 25, 2025
What to do if the cutting carriage on my Battipav Cutter slides unevenly?
- R
  Robert HamiltonAug 26, 2025
  If the cutting carriage on your Battipav Cutter slides unevenly, it is likely that the bearings on the cutting carriage have been damaged. Contact your local dealer to replace the bearings.