Battipav CLASS plus - User Manual

Questions and Answers

A
Austin HolmesAug 3, 2025
What to do if my Battipav CLASS plus Cutter machine does not work?
- M
  maria00Aug 3, 2025
  If your Battipav Cutter machine isn't working, first, ensure the power supply cable is correctly plugged into the socket. Press the plug firmly into the power socket and check the cable for damage. Also, have the socket checked to ensure it has voltage. If these steps don't resolve the issue, the control switch may be damaged, and you should consult your local dealer for a replacement.
H
Hunter ParkAug 8, 2025
Why is my Battipav CLASS plus Cutter machine cutting out of square?
- A
  andrew17Aug 9, 2025
  If your Battipav Cutter machine is cutting out of square, it could be due to a couple of reasons. First, the tile supports might not be at right angles with the cutting disc. Use a square to adjust the tile supports to 90 degrees in relation to the cutting line of the disc. Alternatively, the disc may not be suitable for the material you're cutting, so try replacing it with a more appropriate disc.
Y
ypattonAug 13, 2025
What to do if the laser marker on my Battipav CLASS plus does not work?
- S
  Steven JarvisAug 13, 2025
  If the laser marker on your Battipav Cutter isn't working, it could be that the laser unit or the marker feeder is damaged. Contact your local dealer for a replacement.
M
mayoshannonAug 18, 2025
Why is my Battipav Cutter machine difficult to start?
- R
  Rachel MorrisAug 18, 2025
  If your Battipav Cutter machine is difficult to start, the motor bearings may be damaged. Unplug the power supply cable and consult your local dealer.
D
dandersonAug 23, 2025
Why does the motor of my Battipav CLASS plus give off an unpleasant odor?
- K
  Kimberly CaldwellAug 23, 2025
  If the motor of your Battipav Cutter is emitting an unpleasant odor, water may have seeped inside. Unplug the power supply cable and consult your local dealer.
E
Emily VaughnAug 29, 2025
What to do if lubrication does not arrive at the disk of my Battipav CLASS plus Cutter with the pump running?
- V
  Vernon HughesAug 29, 2025
  If lubrication isn't reaching the disc on your Battipav Cutter when the pump is running, the sprayer unit might be clogged. Dismantle the sprayer assembled inside the disk cover and remove any possible residuals.