Page 12 <&(%$*4.8"4,7%K'*#$"&8#L%/7*,#*%4,77%HMNNNMNIIMOPQP1 Item 63445
?@<6AR ST6;@ACSE D@CEA6E@EU6?6AFT
;*4&(9%T(&9'4$h#%?*(",7%E'5+*(%B*(*-%
E&$*- If product has no serial number, record month and year of purchase instead.
E&$*- Some parts are listed and shown for illustration purposes only,
and are not available individually as replacement parts.
C8$*(8,7%D,"8$*8,84*%
1. Using allen wrench (not included),
remove Hex Screws on Side Cover.
2. Remove Rubber Handle, Side Cover and Rods.
B*b%
?4(*)
?"9*%
U&Z*(
B*b%
?4(*)
;'++*(%
B,897*
;&9#
G'+("4,$"&8
1. 67*Z,$"&8%?4(*)#%,89%U&7'58#
a. Remove both Side Covers.
b. Clean Elevation Screws and Columns.
c. Lubricate with a light coating of
multipurpose grease (sold separately).
2. ;&77*(%U.,"8#
a. Remove left Side Cover.
b. Use chain cleaner (sold separately)
according to manufacturers instructions.
c. Lubricate with chain oil (sold separately),
wipe off excess oil.
;*/7,4"83%!MX*7$
1. Remove right Side Cover.
2. Remove Belt Cover.
X*7$%
U&Z*(
<"3'(*%`
3. Move Belt back and forth on pulleys, while pulling
Belt away from pulleys, one groove at a time.
4. Put new Belt on upper pulley, then move
Belt back and forth onto lower pulley, while
pushing it onto pulley, one groove at a time.
5. Replace Belt Cover, Rods, Right
Panel and Rubber Handle.
6. Replace Hex Screws.
To Next Page
Loading...