Page 6 For technical questions, please call 1-888-866-5797. Item 57006
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
1. Place the Battery Pack on a dry fireproof surface in
a room where the temperature is from 50–104° F.
Note: If recharging a newly spent Battery Pack,
allow it to cool completely before charging.
2. Examine the Battery Pack.
It must be undamaged, and an
20V, Lithium-ion type Battery Pack.
Do not charge a cracked, open, or
leaking Battery Pack, or charge a
non-recommended type of Battery Pack.
3. The Battery Pack’s terminals are designed to fit
this Charger specifically. If the Battery Pack does
to not fit the Charger properly, do not try to insert it.
Do not force a Battery Pack into the Charger.
4. Plug the Charger directly into a grounded,
120VAC, 60Hz receptacle.
5. Slide the Battery Pack onto the Charger.
6. While charging, the Battery Pack and Charger
may become warm to the touch. This is
normal, and does not indicate a problem.
Note: If only the Red LED blinks, then the Battery
Pack and/or Charger are not within the correct
charging temperature or there is a problem with the
Battery Pack or Charger. Allow the Battery Pack and
Charger to reach the proper charging temperature.
Note: If the Green and Red LEDs both blink, then the
Battery Pack or Charger may be damaged. Have them
inspected by a qualified technician before charging.
7. The Green LED will light continuously and the
Red LED will blink when the Battery Pack is
charging. Both the Green and Red LEDs will
light continually when the battery is charged.
Unplug the Charger and disconnect it
from the Battery Pack when finished.
8. Allow the Battery Pack to cool
completely before using it.
9. Press the Battery Button to release
Battery Pack from the Charger.
To Next Page
Loading...