Page 15For technical questions, please call 1-888-866-5797.Item 57003
6. Before beginning work, provide for sparks
and debris that will fly off the work surface.
General Operating Instructions
TO PREVENT SERIOUS INJURY: Grip the tool firmly in both hands.
1. Make sure that the Trigger is not
locked on, then plug in the tool.
2. Squeeze the Trigger to start the tool.
To lock the tool on, press the Lock ON
Button then release the Trigger.
3. Allow the tool to come up to full speed
before touching the work material.
4. Apply the wheel to the work material at a 10° – 15°
angle, allowing the tool to operate at full speed.
If the tool bogs down, use lighter pressure.
5. To create a smoother surface,
keep the tool moving over the work surface.
6. Release the Trigger to stop the tool,
or press and release the Trigger if the
Lock ON Button is engaged.
7. Allow the tool to come to a complete
stop before setting it down.
8. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
SAFETYOPERATIONMAINTENANCE SETUP
To Next Page
Loading...
