Page 14 For technical questions, please call 1-888-866-5797. Item 57003
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its
electrical outlet before installing accessories.
Installing a Non-threaded Grinding Wheel
1. The Grinding Wheel MUST be:
• rated to at least 8500/min.
• no larger than 7″ (180mm) in diameter.
• fitted with a 5/8” round arbor hole.
• no thicker than 0.3".
• suitable for surface grinding, not edge grinding.
• dry and clean.
• proven undamaged by inspection
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange. Keep the Big Flange
and Inner Flange in position on the Spindle.
4. Place Grinding Wheel on Spindle.
5. Thread the Outer Flange onto the Spindle.
Wrench tighten only enough so that the
wheel is securely held on the spindle.
6. WARNING! To prevent serious injury, do
not overtighten flange. Overtightening can
damage the wheel, causing wheel failure.
Installing a Threaded Accessory
TO PREVENT INJURY: Wear heavy-duty work gloves when handling wire wheels and brushes.
These accessories are sharp and can cause injury.
1. The accessory MUST be:
• rated to at least 8500/min.
• no larger than 7″ (180mm) in diameter.
• fitted with a threaded opening of 5/8″ - 11 TPI.
• undamaged.
• a sanding disc and backing pad,
a sanding flap disc, a wire wheel or
a wire cup brush (accessories not included).
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Remove the Outer Flange and the
Big Flange and keep in a safe place.
4. Thread disc accessory firmly onto the Spindle.
Wrench tighten onto the Spindle.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord to
possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
5. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
SAFETY OPERATION MAINTENANCESETUP
To Next Page
Loading...
